Home > News > Content

Laser Water Chiller Installation Instructions-2

May 08, 2017

Laser water chiller installation instructions-2

3, according to the equipment to connect the outlet pipe.

4, plug in the power cord, turn on the power switch of CO2 Laser Water Chiller. No boot!

(1) when the power switch is turned on, the cold water pump starts working. The first time the new machine will boot the pipeline will have more bubbles cause the machine occasionally flow alarm, running a few minutes later will return to normal.

(2) after the first boot, must immediately check whether there is water pipe leakage.

(3) open the power supply, if the water temperature is lower than the set temperature, the fan parts of the Industrial Chiller does not work is a normal phenomenon. The thermostat will automatically control the working state of the compressor, solenoid valve, fan and so on.

(4) due to the compressor and other devices have a longer start-up process, depending on the operating conditions from a few seconds to several minutes, so do not frequent shutdown.